DIN rail case for Raspberry Pi 5 - v3.0 (2026-09-06)
https://raspberry.tips - CC BY 4.0

Parts (PETG recommended):
  din_gehaeuse_wanne      tray, print flat, floor down
  din_gehaeuse_deckel     lid, print flat
  din_gehaeuse_deckelfeld removable field over the GPIO header
  din_traeger_backe       rail jaw, print 4x, STANDING - the STL is already
                          oriented, do not rotate it

Hardware: 8x M3x12 + 8x M3 nuts for the jaws. Nothing for the Pi - it sits on
centring pegs and is held by snap tabs.

Rail: TS35 (DIN EN 60715), fits both 7.5 and 15 mm profiles.
Outer size 91 x 63.5 x 30.7 mm, 40.2 mm above the mounting plane.

Support: put a support blocker over the two snap tabs in the x=0 wall
(tree support grows into the 0.8 mm slits and cannot be removed). Support only
the USB window and the 60 mm GPIO slot.

Source: build_din_traeger.py for FreeCAD 1.1, headless:
  freecadcmd build_din_traeger.py
Fixed dimensions, no parametrics - every body is a named primitive in the tree.

Trademark: "Raspberry Pi" is a trademark of Raspberry Pi Ltd. Call your remix a
"case FOR Raspberry Pi", not a "Raspberry Pi case", and use no raspberry logo.
